Shapes

We can offer our shapes/profiles in the following dimensions. Please note that special properties/limitations specific to the material may apply. If your preferred dimensions are not listed, please get in touch. We will check for technical feasibility or arrange for alternatives.

We supply hot rolled shapes made from our materials produced in the United States.1)

Customised forms such as angle profile or Z profile are possible in widths between 13 mm and 114 mm (0.5 to 4.5 inches) and thicknesses between 7 mm and 67 mm (0.281 to 2.625 inches). The typical length of our profiles is 2,440 mm (8 feet).

Hot rolled flat profiles are available in widths ranging from 102 mm to 432 mm (thickness 10-76 mm).

1) VDM Metals USA produces alloys including the following: VDM® Alloy 25, VDM® Alloy 188, VDM® Alloy 600, VDM® Alloy 617, VDM® Alloy 625, VDM® Alloy 718, VDM® Alloy 722, VDM® Alloy 901, VDM® Alloy C-263, VDM® Alloy X, VDM® Alloy X-750, VDM® Alloy C-276, René 41 (Trademark of General Electric), Waspaloy (Trademark of United Technologies Corp.)

Your contacts

Will Harbison
Will Harbison Sr. VP Commercial vCard
Route VDM Metals USA, LLC 306 Columbia Turnpike Florham Park, NJ 07932

Quality control

Profiles made by VDM Metals pass through especially stringent quality control. At a very early stage, we established quality assurance as the overriding principle and developed it into a quality management system with in-process checks and inspections. This is closely linked to our continuous improvement processes for optimising all operating procedures.